China Corner Protectors For Walls FactoryChina Rubber Water Stop StripChina Sealing Strip For Cabinet Doors SupplierFront Door Rubber Seal for SalePvc Hydroponic Water System For Green Vegetable ManufacturerWholesale Furniture/Door Flexible Plastic Edge Trim Manufacturers
Time Agents Ross Murdock and Gordon Ashe return for another assignment, this time to the tropical island paradise planet of Hawaika. Something apocalyptic has occurred in this planet’s history, altering its topography and cleansing it of all intelligent life. But something goes wrong when they attempt a peek at the past through a Time Gate, and with the Polynesian girl Karara and her trained dolphins Tino-rau and Taua, are plunged into a conflict between a dying super-race, barbarian natives, and invading aliens.
Chapter 01. Lotus World – 00:00
Chapter 02. Lair of Mano-Nui – 22:24
Chapter 03. The Ancient Mariners – 44:34
Chapter 04. Storm Menace – 1:04:53
Chapter 05. Time Wrecked – 1:23:45
Chapter 06. Loketh the Useless – 1:43:14
Chapter 07. Witch’s Meat – 2:01:02
Chapter 08. The Free Rovers – 2:21:05
Chapter 09. Battle Test – 2:42:15
Chapter 10. Death at Kyn Add – 3:03:09
Chapter 11. Weapon from the Depths – 3:22:58
Chapter 12. Baldies – 3:42:50
Chapter 13. The Sea Gate of the Foanna – 4:03:52
Chapter 14. The Foanna – 4:24:21
Chapter 15. Return to the Battle – 4:45:30
Chapter 16. The Opening of the Great Door – 5:07:28
Chapter 17. Shades Against Shadows – 5:27:38
Chapter 18. World in Doubt? – 5:48:06
Our installation tech expert with Swiss Krono discusses the importance of safety gear and the right kind of saw blade to use when cutting laminate flooring planks during the installation process. As he points out, you will always have to cut the floor to length. He cautions to always wear eye protection and an N-95 dust mask, unless you’re using a “dustless” cutter like professionals use. He recommends that you should always cut outside your home.
He shows the correct and incorrect saw blades for comparison. You should use a carbide-fiber tipped saw blade with a high tooth-count. Depending on the size of the saw you’re using, the tooth-count could go up over 100.
The teeth of the saw blade should come in contact with the face of the product. By sawing that way, you reduce chipping. However, chipping is a minor concern because the end that you saw will be hidden under the quarter-round or other trim at the base of the wall or transition.
Remember, laminate flooring is very hard, so you may need more than one blade to finish your project. Even a carbide-tipped saw blade will dull significantly cutting through laminate flooring. If you use a chop saw, you may see sparks and smoke. That’s because you’re sawing through the aluminum oxide wear layer, one of the hardest coatings there is. So it’s good advice to always have a couple of carbide-tipped saw blades handy!