China Edge Trim Plastic ExporterChina Wear Resistant Plastic Cover Strip FactoryFurniture/Door Flexible Plastic Edge Trim China ManufacturersKitchen Cabinet Roller Shutter Doors for SaleT-Shaped Plastic Edge Trim Strip for SaleWholesale Data Strip For Shelf Channel Exporter
Start at 11:00 if you want to avoid all the babbling!
See updates on my garden here: https://www.facebook.com/media/set/?s…
Here’s a link to the small pump: http://amzn.to/1a0p3LV
Find me on Facebook: www.facebook.com/dittobrooks
I got a phone call near the end of the video so the last part got cut off. Here’s the rest:
Tip for short people and tall Tower Gardens!! Why am I pumping out the water? Once every 2 months, remove the water from your Tower Garden and replace with fresh water and nutrients. If you do this faithfully, you’ll get larger and healthier plants. It takes less than 15 minutes per Tower and is so easy to do. Instead of attaching the clear tube that comes with the tower to the top, I pump out through the bottom instead with a separate pump. What I did is bought a small pump on Amazon with a long tube and I use that pump to pump out the tower instead directly through the square opening. I direct the water into my other garden beds. Here’s the link to the small pump that I’m using: http://amzn.to/1a0p3LV
I attach a hose to the pump and pop the pump into the reservoir. I’m doing this instead of attaching the clear hose that comes with the Tower to the top of the Tower. My Tower Gardens are very tall (taller than normal since I’ve added on) so this is kind of hard for me (I’m 5’4″). With three Tower Gardens, this is the simplest way for me to pump out the water with the least amount of hassle.
This is an aeroponic system. The plants grow strong, healthy, and are full of nutrients. It grows vegetables up to 40% faster! No gardening experience necessary. No weeding!
Apply images to surfaces in Autodesk Inventor using the decal feature. Using the decal feature allows 2D images to be wrapped to 3D surfaces within Inventor part files. To apply an image to a surface, create a plane tangent to the surface, then create a 2d sketch and add the image to the sketch. Then, finish the sketch and create a decal by selecting the image and then the surface to which you would like to wrap the image to.
All trademarks are copyright to their respective owners. Any content that is not personally created within the video is used in accordance with fair use policies set forth by respective trademark owners.