China Rubber Sealing T Strip（TPR&PP&PVC&TPE) PricelistChina Shower Rubber Strip FactoryHydroponic Channel FactoryPlastic Roller Shutter For Cabinet Door FactoryWholesale PVC TPE Counter-top Corner Protectors/Guard SupplierWholesale Rubber Seal Supplier
A bright and sparkling FOUR bedroom, TWO bathroom home that hides away at the bottom of this hidden cul-de-sac.
This is the picture-perfect family home BOAST easy access to public transport and parks, and Riverton Forum just minutes away. This is perfect for a busy family who want classy living and space to run and play.
You will love the renovated kitchen and gleaming bathrooms, with generous bedrooms and TWO living areas. But you will be AMAZED at how the back of the home opens out through big bi-fold doors to the monster outdoor entertaining area that overlooks your own fully automatic swimming pool.
Party time, play time or family time this is a generously proportioned home and exceedingly good value.
- 679sqm cul-de-sac location
- ‘Young’ 1990 built (on Young Lane )
- Formal lounge or dining room
- Master bedroom with gold ensuite
- Renovated Granite kitchen with lots of neat cupboards overlooking backyard
- Open plan living
- Bi-fold doors to outdoor entertaining
- 3x Good sized minor bedrooms
- Family bathroom with stunning old style bath tub
- Ducted air-conditioning
- Formal lounge and family room
- Paved outdoor patio entertaining
- Outdoor TV connectivity
- Fully automatic below ground swimming pool
- Bore reticulated gardens
- Garden shed with roller door access
- Rear access
- Double patio
- Front deck
Owners require a fast sale for this lovely family home and all offers will be presented.
This is my 2 liter ebb and flow or flood and drain hydroponics setup. Total parts cost maybe $60-80. I used an old entertainment center that I was about to toss. I cut holes in the shelf to recieve the tops of each of the 2 liter bottles, cut the bottoms off the bottles and inverted them. The fittings I first tried to JB Weld nylon hose barbs into holes drilled in the caps and they almost all failed. My revision was to instead use some cheap corks, drill holes in them and gorrilla glue some PEX tubing pieces into them, then wrap some plumbers/thread tape around the other end of each PEX piece, insert that into the tubing and then double wrap it with zip ties. This ends up being water tight and no leaks. The timer turns the air pump on for 15 min. every six hours and the air pushes the nutrient water down and up the tube into the distribution manifold to each grow chamber. That little green valve in the air line by the pump allows me to adjust how fast the air is released from the nutrient water chamber and thus how fast the grow chambers drain out via gravity. The air valve of course can’t be wide open otherwise the tiny little air pump can’t build the pressure needed to lift the water. If the release valve is all the way closed, the flood happens faster, but it takes too long to drain out and the water just sits in the grow chambers. The grow media is just pea gravel inside a foodsaver bag cut from a roll with pin holes poked into it with a sewing machine. The bag then acts as a sieve and water flows freely in and out of it.