China Gutter HydroponicsChina Non Toxic Hydroponic NFT PVC Channel for SaleChina U Shape Molding Plastic Trip ExporterRubber Strip Seals China ManufacturerSealing Strip Shower ManufacturerWholesale U Molding Plastic Trim Manufacturers
Sill Gaskets & Mull Pads
Sill Gaskets provide a water tight seal and prevents moisture from getting on the dado portion of the frame.
Tested reliability. We manufacture different styles of door bottoms that are designed to fit on most major brands of doors. Our door bottoms incorporate dual durometer extrusions and top-quality design derived from extensive testing. Endura door bottoms offer a superior barrier against air and water. The hardy material used in the leading edge bulb design allows the door bottom to retain its shape and maintain tight contact with the sill.
With “fin” door bottoms, there is only a thin line of contact between the sill and the fin. As illustrated below, time and wear can warp the fins, resulting in a loss of contact between the door and sill. On a traditional door bottom with the “fin” or “finger” design, the fins do not create a consistent seal and this allows even more air and moisture infiltration.
The Leading Edge Bulb Design provides a wider, stronger quality seal to keep back air and moisture. With the bulb design, a continuous seal forms along the dam, creating maximum area of surface contact between the door and sill. The bulb also retains its shape far longer than a fin design, providing long lasting performance.
Force 5 Door Bottoms
Using these door bottoms as part of the Endura Door Component System will improve your doors performance.
Force 5™ Door Bottoms represent the best that our research and development engineers have designed, and are configured to fit a variety of major door brands.
Protective Paint Film
Removing and replacing weatherstrip and corner pads during painting often results in damaged weatherstrip and improperly applied or lost corner pads. Endura provides a thin plastic film covering to weatherstrip and Simple Solution™ corner pads allowing these components to be left in place during painting of exterior frames and doors. Simply remove the film when painting is complete.
Endura’s weatherstrip and Simple Solution corner pads are available in white, tan, and bronze.
This installation video shows how to create a structural expansion joint using expansion joint profiles and expansion joint tape. In this case the EWI / EIF system is made of EPS.
Expansion joints in an external thermal insulation made of rock wool or mineral wool are created the same way.
More info on EIFS / EWIS from Sto: