Hydroponic Pipe/Channel ManufacturersPvc Rubber Edge Strip FactoryPvc Slotted Board China SupplierWholesale Hydroponic Nft Pipe ExporterWholesale Pvc U-Slot Cover For Aluminum Profile for SaleWholesale Rubber Water Sealing Strip Supplier
Watch more Princess Cakes: https://goo.gl/iHB461
BUY MY COOKBOOK: http://cookiescupcakesandcardio.com/?page_id=7366
In this video I teach you how to a make a Disney Frozen cake with my guest star, my NIECE Elsa!
How to make hard candy video: http://youtu.be/_GE645DH6zs
Disney Frozen figurine set: http://amzn.to/1vP6mzr
Visit my blog at: http://cookiescupcakesandcardio.com
Subscribe to my NEW SECOND CHANNEL: https://goo.gl/gIoRUy
• 6″, 8″ round 2 layer cakes
• White buttercream
• 3 sugar cones
• 1 ice cream cone
• Hard candy (shaped in long rectangle pieces, with angled tops)
• Clear sanding sugar
• Snowflake sprinkles
• Small Frozen plastic characters
1. Bake, ice and prepare 6″ and 8″ cakes. Stack cakes on top of each other, lining up the 6″ cake to be at the back of the 8″ cake. Use a small amount of buttercream in between the layers to help them stick together.
2. Place a small amount of buttercream towards the back of the top of the 6″ cake, and place the regular ice cream cone in the centre, with 2 of the sugar cones on either side of it, pointy side up. Place the third cone on top of the regular cone, pointy side up.
3. Using a sharp knife, draw a concave line, following the curve of the cones, and cut out a concave portion of the cake, and remove it.
4. Cover the concave portion, cake board, and cone structure in white icing.
5. Using a sharp serrated knife, cut the hard candy into shaped pieces for the ice castle. I found this to be easiest by cutting gently, and laying the pieces out separate from each other, as they tend to stick to each other. I cut 7 pieces for the background of the castle, and 4-6 pieces for the front of the castle. Elsa, had other ideas for the foreground pieces!!
6. Where the 8″ cake is not covered but the 6″ cake, cover with sanding sugar, and snowflake sprinkles- being careful not to get the icing on the hard candy pieces as they don’t clean off very easily.
7. Place Frozen characters where you desire, and serve when ready!
Protect the side rails of your truck bed with diamond plate bed caps from Dee Zee. Go to http://www.realtruck.com/dee-zee-diamond-plate-truck-bed-caps/ to learn more. This video specifically shows the bed rail installation on a 2004 Dodge Ram 2500 truck.
How to Install Dee Zee Bed Rail Caps
Today we are installing a set of DeeZee diamond-plate bed caps onto an ’04 Dodge Ram 2500.
Here’s all included hardware needed for the installation.
Wipe down the surface area with included alcohol cleaning pads. If you are replacing old bed caps, make sure to clean off all 3M tape. As soon as the driver side is wiped clean, peel the protected 3M tape backing and apply bedrail to applicable area. Make sure the front and rear edges line up with the truck’s bedrails.
Then simply repeat on the passenger side. Once finished, these bad boys will bold the outline and contours of your ride, giving it a nice new look.